SpeedyBee F745 35A BLS AIO 25.5x25.5
Important NOTE:
Make sure the slightly larger AIO size is suitable for your own quad!The size of this AIO is 36.5 (L) x 36.5 (W) x 7.0 (H) mm.
We recommend you to use this AIO on your 3.5" to 5" Cinewhoops/Long Range or lightweight quads. For quads under 3.5", please check carefully if your quad has enough space for this AIO.Scope of delivery:
1x SpeedyBee F745 35A BLS AIO 25.5x25.5
1x 35V 470uF capacitor
1x 70mm XT30 power cable
1x 6pin DJI Air Unit cable
1x External USB post module
5x M2x12mm screw
1x M2x6.6mm Vibration-resistant silicone grommets
5x M2 silicone o-rings
5x M2 nylon hex nut
1x Instructions & App Download Card
SpeedyBee F745 35A BLS AIO 25.5x25.5
Product name: SpeedyBee F745 35A BLS AIO Power input: 3-6S LiPo Assembly: 25.5 x 25.5mm Dimension: (LxWxH): 36.5 x 36.5 x 7mm
recommended for quads from 3.5 inches
Weight: 10.1 g MCU: STM32F745 IMU (gyro): MPU6000 USB connection: You need a USB Type-C module
solder to the pads D+, D- and GND.
Barometer: BMP280 OSD: Supports BLE Bluetooth: Supports
Will be used for the
parameter configuration
used,
integrated 2.4 GHz Wi-Fi and
Bluetooth combo chip
Wireless flashing
the FC firmware:
Supports Download Blackbox,
analyze:
Supports 6-pin connector
for DJI Air Unit:
Built-in Flash (for BlackBox): 8 MB current sensor: Supports
scale = 256
BetaFlight
Camera control pad:
Yes (CC pad) 5V output: 4 groups with 5V output.
The total current load
is 2.5 A.
9V output: No one ESC signal pads: M1 to M4 UART: Full UART * 4
(UART1, UART2, UART3, UART4)
ESC telemetry UART: No one I2C: Supports LED pad: Will be for
WS2812 LED used
Summer: BZ+ and BZ- Pad for
5V buzzer used
BOOT button: Used to enter the
to enter DFU mode.
RSSI input: Not supported SmartPort: Not supported Supported flight control: BetaFlight (Standard) Firmware target name: SPEEDYBEE F745AIO
